Festool Roundover Bit HW for OFKC 500

This round-over router bit is designed for clean, precise edge profiling on both plastic edge banding and solid wood. It delivers smooth, consistent results for a refined edge finish on small and detailed work pieces. Its hollow, direct-thread design mounts straight onto the trim router shaft—no collet required—for stable, wobble-free cutting and excellent run-out accuracy. The result is a smooth, uniform round-over and a clean routing pattern with minimal setup and maximum control.
  
Product Strengths

• Low profile design: Allows routing in rabbets or across stacked panels
• Precision-ground radius: Ensures smooth, accurate profiles and a consistent finished edge
• Round-over profile: Designed for clean, uniform edge rounding
• Surface protection: The radius transitions into a 5° relief angle for smoother exits and reduced surface marking
• Two cutting edges: Dual carbide cutting edges provide longer life and consistent cutting performance