WoodOwl 6000 Series Standard Single Spurred Auger Bits

These bits are classified as a Combination Spurred Ship Auger Bits. They have a single flute, single cutting head with a single spur (the outer cutting edge that scores the outside of the hole). They cut very cleanly as the spur scores the outside edge of the hole before the cutter head clears material. 

The outside spur and can be damaged if it hits a nail. This bit cuts very fast due to the single flute design which provides efficient chip ejection. It is hand sharpened at the factory which also enhances cutting speed. This bit is not cast or forged but milled and ground from a solid round blank. The sharp lead screw is also precision ground and machined allowing this bit to start immediately into wood once the drill is started. The machining process produces a bit that is perfectly concentric with very little wobble. It will drill an accurate diameter hole, requiring less energy to power through wood and will create less heat. It will also drill straight and true through all types of wood with minimal wandering. 

These bits are made from high-carbon S55C steel specially designed for WoodOwl bit, and are fully induction hardened from tip to shank. The flute has a phosphate coating (Parkerizing) to facilitate chip ejection and to protect from corrosion. This bit can be used in cordless or corded drills and hand braces. This bit can be re-sharpened using a WoodOwl feather sharpening file.