Whiteside Stile & Rail Sets

Make full size Stile and Rail joints on your router table. The interlocking design plus the raised panel groove are both cut in one pass. Ball bearing guides control the cutting depth and also allow use on rounded, arched, or special shaped doors. With these two piece sets, simply switch router bits to change from cutting stiles to cutting rails. Features a 1/4" tall x 3/8" deep tongue. Ideal for stock from 5/8” to 7/8” thick.

CABINET CONSTRUCTION: Make full size Stile and Rail joints on your router table with this two-piece set. Supplied in a protective case.

SINGLE PASS: The interlocking design plus the raised panel groove are both cut in one pass.

BALL BEARING GUIDE: A ball bearing guide controls the cutting depth to ensure accuracy in the profile and to control the tongue length. Allows for use on rounded, arched, or special shaped doors.

TWO PIECE SET: Simply switch router bits to change from cutting stiles to cutting rails.

TONGUE AND STOCK SIZES: Creates a 1/4" tall x 3/8" long tongue. Ideal for stock from 5/8" to 7/8" thick.

Uses Bearing #: B5

Recommended RPM: 12,000-14,000 (max 16,000)

⚠️WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov