Bob Smith Industries SUPER-GOLD+™ Odorless CA 1 oz. Glue, INSTA-SET™ Spray 2 oz.
SUPER-GOLD+™ is foam-safe, odorless super glue. Super glues can produce fumes that can be irritating to the eyes and nose. While not toxic, some people can become sensitized to these fumes. SUPER-GOLD+™ is BSI’s odorless form of Cyanoacrylate that gives the same high performance characteristics as BSI’s Insta-Cure+ without the irritating fumes. SUPER-GOLD+™ will not fog clear plastic and glass, which can occur with the use of standard Cyanoacrylates. It can also be used on all foams. The cost may be higher, but the added benefits make SUPER-GOLD+™ the best quality adhesive for the consumer.
INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET™ in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. Applying an additional bead of thick CA along a seam and then curing it with INSTA-SET™ significantly enhances a joint’s strength. For difficult to bond materials, INSTA-SET™ can be applied to one surface and CA to the opposite surface. When brought together, they will bond instantly. INSTA-SET™ is formulated with a strawberry scent and activates CA in 6 to 8 seconds without any degrading of the CAs strength, which can occur with many other accelerators. It is compatible with all surfaces, even clear plastic and white foam.
Directions for SUPER-GOLD+™: Unscrew top from nozzle. For finer applications, use the extender tip. Apply SUPER-GOLD+™ CA to one side of the parts being joined, then hold them tightly together for 5-15 seconds. For larger bonding areas, apply serpentine beads of the CA with enough spacing to allow for the spreading of the adhesive. INSTA-SET™ accelerator must be used when bonding two pieces of foam together. Full strength is reached in three hours. Wipe the nozzle clean before replacing screw-on top. Refrigerate to extend shelf life. Cured CA is stable from -40 to 220°F. Soak extender tip in acetone for cleaning.
Directions for INSTA-SET™: After joining parts with cyanoacrylate (CA, super glue), spray the seams with INSTA-SET™ to cure the CA in 8 seconds. A bead of CA can then be applied to the outside and corners of joints before another application of INSTA-SET™ to reinforce their strength. INSTA-SET™ can also be applied to one part (with CA on the other) before joining for difficult to bond materials. INSTA-SET™ is compatible with all surfaces, including clear plastic and all foams. It also is a great cleaning agent for adhesive residue and scuff marks. Store separately from CAs.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov