Skip to content
COVID-19 Update: We are open and safely shipping orders with minimal delays. Curbside pickup is available for local orders.
COVID-19 Update: We are open and safely shipping orders with minimal delays. Curbside pickup is available for local orders.

Bob Smith Industries GRIP-IT™ 1 oz. Super Glue & INSTA-SET™ CA Accelerator 2 oz.

$13.99
SKU 222H151H

GRIP-IT™ has been specifically formulated for applying grips and mats for recreational vehicles. GRIP-IT™ works great on all makes of grips for motorcycles, jet skis, snowmobiles and bicycles. GRIP-IT™ has a 10-25 second working time and the grip is rideable within 5 minutes. GRIP-IT™ also works great for replacing rubber mats. Available in a 1 oz. bottle that will bond up to 12 sets of grips. 

INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET™ in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. Applying an additional bead of thick CA along a seam and then curing it with INSTA-SET™ significantly enhances a joint’s strength. For difficult to bond materials, INSTA-SET™ can be applied to one surface and CA to the opposite surface. When brought together, they will bond instantly. INSTA-SET™ is formulated with a strawberry scent and activates CA in 6 to 8 seconds without any degrading of the CAs strength, which can occur with many other accelerators. It is compatible with all surfaces, even clear plastic and white foam.

Directions for GRIP-IT™: Clean the bar area with rubbing alcohol. Unscrew top from nozzle. For finer applications, use the extender tip. Before applying any glue to the grip, have a disposable rag or paper towel within reach to be able to quickly wipe away any excess glue during application. Also place a piece of cardboard or paper plate below the working area to catch any excess glue drip. Apply 4 small beads of GRIP-IT™ to outer 2" of the handle bar, then apply a generous amount of GRIP-IT™ to the inside flange of the grip. Align the grip before sliding on, then slide the grip quickly into place. You may need to slightly twist and turn the grip as you slide it into position. Once in position wipe away any excess glue. Glue will set in 10-25 seconds. NOTE: On twist throttles replace sleeve if damaged. Cover any vent holes in sleeve to prevent bonding with handlebar.

Directions for INSTA-SET™: After joining parts with cyanoacrylate (CA, super glue), spray the seams with INSTA-SET™ to cure the CA in 8 seconds. A bead of CA can then be applied to the outside and corners of joints before another application of INSTA-SET™ to reinforce their strength. INSTA-SET™ can also be applied to one part (with CA on the other) before joining for difficult to bond materials. INSTA-SET™ is compatible with all surfaces, including clear plastic and all foams. It also is a great cleaning agent for adhesive residue and scuff marks. Store separately from CAs.

Prop 65WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov